Is there a chance you could add 'Contol Number' to the Depreciation Setup screen?  Everywhere else in SoftBase, the Control number is important, even required; but, here, in this application, where it would be very useful when searching for a particular piece of equipment, it shows only the Serial#, which I usually don't have when looking for something.   

It shows the control# when you click on an item, but if I'm looking for a particular control number unit, I have to go into Equipment, key in the control number to find the serial #, then go back to Depreciation Setup, etc.  , or else click on each item until I run into the item I want.

Just a long way to go when it would be so much easier and quicker to get the job done if there was a Control Number column on the Depreciation Setup function.  Time is money.

Thanks,

Benco Industrial Equipment, LLC